How to use window sealing strips

How to use window sealing strips a. Glass gasket strips and end-stop rubber strips: (windows, window sashes) should be welded and cleared, the rubber strips should be aligned in the correct direction with a special roller to reduce the amount of rubber strips and mechanical seals. Push into the slot of the profile, and press the head of the rubber strip down into the slot of the embedded profile. Because the rubber strip is an elastic body, it may shrink after being rolled. The correct method is: when the rubber strip is installed at the interface of the two ends, retract the two ends of the rubber strip to the center a little, and leave 2-3 cm Shorten the margin, then cut and insert into the notch b. Glass bead: Insert the top part of the rubber strip into the profile groove by manual method according to the correct surface, and then press the outer surface of the rubber strip firmly, and the mechanical seal will remove the rubber strip. Press into the open space of the glass and profile. The rubber strips at both ends are retracted a bit toward the center, leaving a length of 1-2 cm, and then cut off, and press into the notch.