After the rainstorm, which parts of the wading vehicle need some maintenance

After the rainstorm, which parts of the wading vehicle need to be maintained? 1. After lightly stepping on the brake pedal and driving out of the watery road, you can lightly step on the brake pedal several times. The purpose of this is for the Grundfos mechanical seal to make the brake pads and brake discs break In case of conflict, the water attached to it will evaporate or spin dry, so that it can recover the braking effect most quickly. 2. Check the engine compartment and the bottom of the vehicle. Open the engine cover to check the working condition of the engine, check whether there is any dirt such as leaves on the mechanical seal of the radiator fin of the water tank, whether the tire is damaged, and whether there is any dirt such as plastic bag coiled under the chassis Wait. 3. Car wash It is recommended that car owners go to 4S shops and car beauty shops to clean their cars after they have tried standing water and rain to prevent sand, leaves and other integrated mechanical seals from entering the engine air intake system to form engine, circuit, and paint components. The component is damaged. Wipers, our frequency of use is very high, but we also need to check them specifically to avoid some potential safety questions caused by the question of wipers. When we use the wiper, if we find that the wiper and the glass are in conflict with an abnormal noise, or we find that the wiper 'jumps' on the glass and leaves a lot of marks, then the wiper needs to be replaced. We list some of the most common windshield conditions when the windshield wiper is short of: the cause of the occurrence of band streaks: the wiper strip is not in full contact with the glass. Solution: Check the wiper assembly or replace the wiper with a new one. The cause of fogging streaks: There is grease on the car glass, or there may be grease on the wiper. Solution: Use a neutral detergent to clean up the glass or grease on the wiper. The cause of abnormal noise occurs when the wiper is working. The wiper strip is worn, and the arm and bracket are damaged. Solution: Replace the wiper or check the wiper assembly. The reason for cracks/hardening of the rubber strip: the quality of the wiper is low, and it may reach the service life due to corrosion by chemicals. Solution: Replace the wiper. If it is not used for a long time or the air in the environment is dirty, it will cause a lot of dirt, such as dust, leaves, etc., to accumulate inside the skylight. These debris will be washed by rainwater into the sunroof drainage channel and block the sunroof drainage pipe. When the drainage pipe is blocked, the accumulated water in the drainage channel will exceed the height of the drainage channel and enter the interior of the vehicle in the future, causing damage to the vehicle interior. (Note: Your car has a sunroof, please check the seal of the sunroof carefully before the onset of the dry season) The sunroof drainage pipes we are talking about are generally located at the four corners of the sunroof, connected to the sunroof drainage groove and adjacent to the front and rear fender Of drainage holes. Therefore, it is best to check some of these places before the rainy season arrives to avoid 'the rain falls from the sky.' Use the sunroof to pay attention to matters: 1. Before opening the sunroof, pay attention to whether there are obstacles on the roof that prevent the sunroof from sliding. 2. When shaking the distance, try not to use skylights to avoid damage to the skylights and slide rails due to vibration. 3. When it is raining or cleaning the vehicle, stop turning the sunroof to avoid acid rain or water droplets from aging and rusting the rubber strip and metal in the sunroof. 4. Suppose you live in a frigid zone. When there is freezing outdoors, please do not open the skylight forcibly. The resistance caused by freezing can damage the mechanical components and even burn the motor. Maintenance of skylights: 1. Punctually eradicate dust, sand and fallen leaves on the sliding rails of the skylights. 2. When washing the car in the car wash room, do not use a high-pressure water gun to spray on the sealing ring around the sunroof to avoid deformation of the sealing ring under the spray pressure of the high-pressure water jet. 3. During each maintenance, please lubricate the skylight by the 4S shop. In heavy rain and fog, the fog lights of vehicles can provide a great help to our driving safety. In short, it not only provides lighting, but also informs other vehicles of your location and reduces the occurrence of traffic accidents. Regarding the inspection of the fog lamp, we need to pay attention to whether the light can work normally in normal hours, and check whether there is water leakage in the fog lamp. If there is any doubt, it needs to be repaired in time. In addition, only the fog lights are mentioned here. If the front and rear headlights also show signs of water ingress, please clean them up in time. Friends who drive have this experience. When we enter the car with an umbrella, there is rain on the soles of our feet and on the umbrella, so the rain will easily stain our interiors and even soak some of the interiors. Therefore, we can replace our car with rubber foot mats before the onset of the dry season, and prepare a storage box in the trunk, where we can put a wet car wipe or an umbrella. At the top of the list of things to pay attention to when choosing rubber foot pads, choose foot pads with a small taste, because the foot pads are plastic products, and the plastic itself has an impact on the taste. Therefore, choosing a foot pad with a smaller taste is also beneficial to our health. help. Second, look at the cleats in detail. The plan for good foot pad cleats will be thicker, while for low-quality products, the plan for cleats is very soft and thin, and the roots are not anti-slip. Keywords: Grundfos mechanical seal, imported mechanical seal, cartridge mechanical seal