regular maintenance of hydraulic cylinders - business
This is possible only when the hydraulic cylinder is subject to daily inspection and maintenance.You will know that the hydraulic system is complex and the maintenance is complex.This article is about the common maintenance required for the hydraulic cylinder system.
Bending rods are very rare in the case of a hydraulic cylinder system, as they can only be formed due to design defects.The common cause of bending the rod is that the diameter of the rod is insufficient or the installation arrangement is irregular.Due to the poor quality of the material used to manufacture the hydraulic cylinder system, bending rods may also occur.
If the bending rod is not corrected in time, this may damage the entire system in the long run.Obviously, the rod of the hydraulic cylinder system should be checked regularly for straight.The working pressure of the hydraulic cylinder has a great influence on the expansion of the cylinder pipe.
The balloon tube will guide the braking of the fluid seal and leakage.If this problem is left unattended, the efficiency of the hydraulic cylinder will be greatly reduced.Therefore, the cylinder tube must be checked regularly to ensure the maximum efficiency of the system.
This is an important maintenance step that needs to be taken to ensure the long life of the seal.Insufficient bearing area will bring a huge load to the piston seal.This load will be much higher than the load that the seal can withstand.
Therefore, in the long run, the seal will fail and the sealing system will eventually need to be completely replaced.Check if there is an abnormality in the bearing area, and if there is an abnormality, correct it to ensure that the service life of the seal is long.The rod has special roughness requirements.
If the surface is very rough, it is possible for the fluid to leak.For very smooth surface rods, the life of the seals will be reduced.You must regularly check the surface finish of the bar and make sure it meets the set standards.
Inspection and maintenance of all these components will ensure the long life and maximum efficiency of the hydraulic cylinder