Mechanical seal manufacturer to tell you the installation steps and matters needing attention

Mechanical seal manufacturer to tell you the installation steps and matters needing attention - 2019 5 - 27 according to different conditions, the installation of the mechanical seal is also a gap, the mechanical seal manufacturer to tell you the installation steps and matters needing attention. 1. Determine the size of installation, should according to the instructions on the use of the products or samples, to ensure that the mechanical seal installation size. 2. Before loading, axis ( Collar) , gland should be no burr, bearing in good condition; Seal, shaft, sealing cavity, gland should be cleaned. In order to reduce frictional resistance, and shaft installed on the part of the mechanical seal to thin coated with a layer of oil, for lubrication, considering the intermiscibility of rubber o-ring, if not oil, but with soap and water. Without a stop pin float mounted static ring structure, should not be oiled, into the gland should be dry. 3. Static ring with gland first installed on the shaft, be careful not to into the shaft, then the ring components into. Spring bridge or transmission of the set screws should be evenly tighten several times. 4. Before his fixed gland of compensation loop for axial compression with the hand, loosen after compensation ring can automatically back no card lag phenomenon, then gland nut evenly tied to lock. Looked at the above content, believe everybody already knows the mechanical seal installation steps and matters needing attention. More mechanical seal manufacturer information click: