Common mechanical seal damage and treatment methods in reactors

The common mechanical seal damage of the reactor and the treatment method. During the use of the reactor, the damage often occurs. The most common damage to the mechanical seal of the reactor and the treatment method are: 1. Damage of the mechanical seal 1. In the process of long-term use of mechanical seal equipment, the end face of the dynamic ring may be bumped or deformed. 2. Once the specific pressure of the end face of the mechanical seal equipment is too large, the mechanical seals used in the kettle will conflict and thermal deformation will occur. 3. If the sealing ring of the equipment is incorrectly selected, it will affect the pressing force of the equipment. If the pressing force of the mechanical seal of the kettle is not good, or if the V-shaped sealing ring of the equipment is installed reversely, the sealing ring will be lost. Some sealing effect. 4. The axis of the mechanical seal of the reactor and the end face of the static ring will have a large straight difference. 5. Once the temperature of the mechanical seal equipment is unstable and the operating pressure is abnormal, hard particles will enter the conflict pair. 6. Do not exceed the target for the amount of shaft series. 7. If there is leakage in the inlay seam of the movable ring or the fixed ring in the bonding or inlay, the mechanical seal will be damaged. 2. How to deal with the mechanical seal 1. If the conflict pair is damaged, the conflict pair must be replaced, or the conflict pair can be ground from the beginning. 2. Strengthen the cooling system, adjust the specific pressure properly, and take away the heat in time. 3. The device must be reasonable, and the sealing ring material must meet the pressing force. 4. The reactor must be shut down for maintenance, and it must be rectified from the beginning to ensure its straightness. 5. Strictly control the technical goals, and do not allow crystals and particles to enter the conflict. 6. Repair the shaft and adjust the shaft to make the shaft more standardized. 7. To improve the technology of this device, the adhesive must be strong.